Abstract
In order to achieve the target of reducing oil consumption to zero for pulverized coal (PC) boiler in power plant, the paper developed a novel coal pulverized ignition approach, called as Alternating-Current plasma (AC plasma) ignition, with the advantages of excellent PC combustion behavior and longer electrode life-span. The scientific principle of how to generate the AC plasma arc was elaborated in detail. First, the experiments on life-span of electrodes inside AC plasma generator had been conducted, finding a workable way to extend its life-span beyond 530 hours. Second, a new AC plasma burner specifically designed for lean coal according to the principle of PC staged combustion had been illustrated with diagrams and then used to ignite the PC-air stream under four kinds of conditions with a varying AC plasma power from 150 kW to 300 kW, focusing on analyses of the influence of AC plasma power on combustion behaver, such as combustion temperature, carbon burnout rate as well as PC combustion regime. The following results showed that in the case of the power of the AC plasma was P=300 kW, a satisfied PC combustion process could achieved, with the average PC combustion temperature of about 940°C, combustion flame length of 6.3 m, and the total carbon burnout rate of up to 52.2%. In addition, about 80% of the nozzle outlet section was filled with bright flame, while 81% of the PC was in zone of the cylindrical flame regime. The PC combustion modes were changed repeatedly during the process of combustion, which went from homogeneous combustion mode at initial ignition stage to combined combustion mode and heterogeneous combustion mode at middle stage, finally to combined combustion mode at later stage. The research conclusion in this paper has proved that the AC plasma ignition approach is feasible and effective to ignite low-rank coal without the present of fuel oil.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Liu C.L., Li Z.Q., Kong W.G., et al., Bituminous coal combustion in a full-scale start-up ignition burner: Influence of the excess air ratio. Energy, 2010, 35: 4102–4106.
Yan G.C., Qi X., Ren T., et al., Ignition characteristics of high-temperature oxygen generator in pulverized coal stream. Journal of Harbin Engineering University, 2016, 37: 568–572.
Messerle V.E., Karpenko E.I., Ustimenko A.B., Plasma assisted power coal combustion in the furnace of utility boiler: Numerical modeling and full-scale test. Fuel, 2014, 126: 294–300.
Samuel E.A., Collection efficiency of electrostatic precipitators by numerical simulation. Environment International, 1981, 6: 137–152.
Navarrete B., Vilches L.F., Canadas L., et al., Influence of start-ups with fuel-oil on the operation of electrostatic precipitators in pulverized coal boilers. Environmental Progress, 2004, 23: 29–38.
Liu C.L., Li Z.Q., Kong W.G., Zhao Y., et al., Influence of coal-feed rates on bituminous coal ignition in a full-scale tiny-oil ignition burner. Fuel, 2010, 89: 1690–1694.
Lei C., Fan H.J., Wu L., Numerical simulation on tiny-oil ignition technology for pulverized-coal burners. Journal of Chinese Society of Power Engineering, 2011, 31: 165–169.
Li Z.M., Application of ignition technique with tiny gasified oil for 700 MW subcritical boiler. Boiler Technology, 2015, 46: 65–69.
Yan G.C., Qi X., Ren T., et al., Research on the ignition characteristic of the high-temperature generator in the w-shape flame boiler. Journal of Chinese Society of Power Engineering, 2016, 4: 6–14.
Liu G.W., Dong P., Bie R.S., Experimental study and numerical simulation on high-temperature oxygen-enriched oil-free pulverized coal Ignition. Journal of Chinese Society of Power Engineering, 2013, 11: 833–840.
Yan G.C., Qi X., Ren T., et al., Ignition character of pulverized anthracite coal stream in specific high-temperature oxygen atmosphere. Proceedings of the CSEE, 2016, 36: 1016–1024.
Ju Y., Sun W., Plasma assisted combustion: dynamics and chemistry. Progress in Energy and Combustion Science, 2015, 48: 21–83.
Messerle V.E., Ustimenko A.B., Lavrichshev O.A., Comparative study of coal plasma gasification: Simulation and experiment. Fuel, 2016, 164: 172–179.
Ma J., Zhang M., Su B.G., et al., Numerical simulation of the entrained flow hydropyrolysis of coal in magnetically rotating plasma reactor. Energy Conversion and Management, 2017, 148: 431–439.
Ibrahimoglu B., Yilmazoglu M.Z., Numerical modeling of a downdraft plasma coal gasifier with plasma reactions. International Journal of Hydrogen Energy, 2020, 45: 3532–3548.
Messerle V.E., Ustimenko A.B., Lavrichshev O.A., Plasma coal conversion including mineral mass utilization. Fuel, 2017, 203: 877–883.
Belosevic S., Sijercic M., Stefanovic P., A numerical study of pulverized coal ignition by means of plasma torches in air-coal dust mixture ducts of utility boiler furnaces. International Journal of Heat and Mass Transfer, 2008, 51: 1970–1978.
Zhang H.G., Zhou J.H., Problems and solutions in the application of plasma ignition technology in 660 MW ultra-supercritical units. Journal of Shanghai Electric Power University, 2016, 32: 84–86.
C.Y. Han, Xu M.H., Zhou H.C., et al., Pulverized coal combustion, sixth, ed., Science Press, Beijing, 2001, pp.: 309–325.
Costa M., Silva P., Azevedo J.L.T., Measurements of gas species, temperature, and char burnout in a low-NOx pulverized-coal-fired utility boiler. Combustion Science and Technology, 2003, 175: 271–289.
Hwang J., Bae C., Park J., et al., Microwave-assisted plasma ignition in a constant volume combustion chamber. Combustion and Flame, 2016, 167: 86–96.
Fang C.Q., Jiang X.G., LV G.J., et al., Chemical synthesis residual pyrolysis and combustion: kinetics and evolved gases investigated by TG-FTIR. Journal of Thermal Science, 2020, 29(1): 108–114.
Acknowledgements
This work was supported by the national natural science foundation of china (Contract No. 51806132) and doctor start-up capital of Shanxi University (No. 20174462).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Yan, G. Ignition Characteristics of Lean Coal Used a Novel Alternating-Current Plasma Arc Approach. J. Therm. Sci. 31, 571–581 (2022). https://doi.org/10.1007/s11630-022-1452-9
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11630-022-1452-9