Abstract
During deep buried hard-brittle rock tunnel excavation, the surrounding rock experiences a complicated stress path and stress adjustment process. Once the adjusted stress exceeds the ultimate bearing capacity of rockmass, a rock failure mode defined as stress-cracking type will occur. In order to investigate the effect of stress paths on failure mechanism and progressive damage of deep-buried rockmass, the cyclic loading-unloading, loading-unloading, uniaxial, conventional and unloading triaxial compression tests on samples of hard-brittle sandstone were conducted. According to the experimental results, increase in the confining pressure was beneficial to improve the mechanical parameters of rock, but it will reduce the brittle failure features. Compared with conventional triaxial compression, the sandstone under unloading state had more remarkable stress drop and unstable failure characteristics. Meanwhile, it was found that the energy dissipation and energy release in the whole process of rock deformation were the internal power of driven rock progressive damage. With the increase of confining pressure, the energy hardening and energy accumulation features of rock were weakened, while the progressive damage evolution characteristics could be enhanced. In unloading state, more energy could be converted into elastic energy in the energy softening phase (σeb-σP), so that the pre-peak damage rate of rock was lower than that of conventional triaxial compression state. Thus, the energy dissipation rate of rock after peak strength decreased linearly with the increase of confining pressure under conventional triaxial compression state, while in unloading state it showed the opposite law.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Barla G, Bonini M, Semeraro M (2011) Analysis of the behaviour of a yield-control support system in squeezing rock. Tunn Undergr Space Technol 26(1): 146–154. https://doi.org/10.1016/j.tust.2010.08.001
Cantieni L, Anagnostou G (2009) The effect of the stress path on squeezing behavior in tunneling. Rock Mech Rock Eng 42: 289–318. https://doi.org/10.1007/s00603-008-0018-9
Chen ZQ, He C, Wu D, et al. (2017) Fracture evolution and energy mechanism of deep-buried carbonaceous slate. Acta Geotech 12(6): 1243–1260. https://doi.org/10.1007/s11440-017-0606-5
Chen ZQ, He C, Ma GY, et al. (2019) Energy damage evolution mechanism of rock and its application to brittleness evaluation. Rock Mech Rock Eng 52: 1265–1274. https://doi.org/10.1007/s00603-018-1681-0
Cui Z, Sheng Q, Leng X, Ma YL (2019) Investigation of the long-term strength of Jinping marble rocks with experimental and numerical approaches. Bull Eng Geol Environ 78(2): 877–882. https://doi.org/10.1007/s10064-017-1132-2
Diederichs MS, Kaiser PK, Eberhardt E (2004) Damage initiation and propagation in hard rock during tunnelling and the influence of near-face stress rotation. Int J Rock Mech Min Sci 41: 785–812. https://doi.org/10.1016/j.ijrmms.2004.02.003
Dwivedi RD, Singh M, Viladkar MN, Goel RK (2013) Prediction of tunnel deformation in squeezing grounds. Eng Geol 161: 55–64. https://doi.org/10.1016/j.enggeo.2013.04.005
Feng XT, Yu Y, Feng GL, et al, 2016. Fractal behaviour of the microseismic energy associated with immediate rockbursts in deep, hard rock tunnels. Tunn Undergr Space Technol 51: 98–107. https://doi.org/10.1016/j.tust.2015.10.002
Huang D, Li YR (2014) Conversion of strain energy in triaxial unloading tests on marble. Int J Rock Mech Min Sci 66: 160–168. https://doi.org/10.1016/j.ijrmms.2013.12.001
Hua AZ, You MQ, 2001. Rock failure due to energy release during unloading and application to underground rock burst control. Tunn Undergr Space Technol 16: 241–246. https://doi.org/10.1016/S0886-7798(01)00046-3
Khazaei C, Hazzard J, Chalaturnyk R (2015) Damage quantification of intact rocks using acoustic emission energies recorded during uniaxial compression test and discrete element modeling. Comput Geotech 67: 94–102. https://doi.org/10.1016/j.compgeo.2015.02.012
Li DY, Sun Z, Xie T, et al. (2017) Energy evolution characteristics of hard rock during triaxial failure with different loading and unloading paths. Eng Geol 228: 270–281. https://doi.org/10.1016/j.enggeo.2017.08.006
Lim A, Ou CY (2017) Stress paths in deep excavations under undrained conditions and its influence on deformation analysis. Tunn Undergr Sp Tech 63: 118–132. https://doi.org/10.1016/j.tust.2016.12.013
Liu GF, Feng XT, Feng GL, et al. (2016) A method for dynamic risk assessment and management of rockbursts in drill and blast tunnels. Rock Mech Rock Eng 49(8): 3257–3279. https://doi.org/10.1007/s00603-016-0949-5
Li TB, Ma CC, Zhu ML, et al. (2017) Geomechanical types and mechanical analyses of rockbursts. Eng Geol 222: 72–83. https://doi.org/10.1016/j.enggeo.2017.03.011
Li XB, Cao WZ, Zhou ZL, Zou Y (2014) Influence of stress path on excavation unloading response. Tunn Undergr Space Technol 42: 237–246. https://doi.org/10.1016/j.tust.2014.03.002
Ma CC, Li TB, Xing HL, et al. (2016) Brittle rock modeling approach and its validation using excavation-induced micro-seismicity. Rock Mech Rock Eng 49(8): 3175–3188. https://doi.org/10.1007/s00603-016-0941-0
Ma CC, Li TB, Zhang H (2020) Microseismic and precursor analysis of high-stress hazards in tunnels: A case comparison of rockburst and fall of ground. Eng Geol 265: 10543. https://doi.org/10.1016/j.enggeo.2019.105435
Martin CD, Chandler NA (1994) The progressive fracture of Lacdu Bonnet granite. Int. J. Rock Mech. Min Sci Geomech Abstr 31: 643–659. https://doi.org/10.1016/0148-9062(94)90005-1
Munoz H, Taheri A, Chanda EK (2016) Rock drilling performance evaluation by an energy dissipation based rock brittleness index. Rock Mech Rock Eng 49(8), 3343–3355. https://doi.org/10.1007/s00603-016-0986-0
Xiao YX, Feng XT, Li SJ, et al. (2016) Rockmass failure mechanisms during the evolution process of rockbursts in tunnels. Int J Rock Mech Min Sci 83: 174–181. https://doi.org/10.1016/j.ijrmms.2016.01.008
Xie HP, Ju Y, Li LY (2005) Criteria for strength and structural failure of rocks based on energy dissipation and release principles. Chin J Rock Mech Eng 24: 3003–3010. (In Chinese) http://orcid.org/0000-0002-1686-7827
Xu H, Feng XT, Yang CX (2019) Influence of initial stresses and unloading rates on the deformation and failure mechanism of Jinping marble under true triaxial compression. Int J Rock Mech Min Sci 117: 90–104. https://doi.org/10.1016/j.ijrmms.2019.03.013
Yan P, Lu W, Chen M, et al. (2015) Contributions of in-Situ stress transient redistribution to blasting excavation damage zone of deep tunnels. Rock Mech Rock Eng 48: 715–726. https://doi.org/10.1007/s00603-014-0571-3
Yang SQ (2016) Experimental study on deformation, peak strength and crack damage behavior of hollow sandstone under conventional triaxial compression. Eng Geol 213: 11–24. https://doi.org/10.1016/j.enggeo.2016.08.012
Acknowledgments
This research was supported by the National Natural Science Foundation of China (No. 52008351), the Sichuan Science and Technology Program (No. 2021YJ0539), the project funded by China Postdoctoral Science Foundation (No. 2020TQ0250), the Open Foundation of MOE Key Laboratory of Engineering Structures of Heavy Haul Railway (Central South University) (No. 2020JZZ01) and the Open Foundation of State Key Laboratory of Geohazard Prevention and Geoenvironment Protection (Chengdu University of Technology) (No. SKLGP2021K019).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Chen, Zq., He, C., Hu, Xy. et al. Effect of stress paths on failure mechanism and progressive damage of hard-brittle rock. J. Mt. Sci. 18, 2486–2502 (2021). https://doi.org/10.1007/s11629-020-6554-9
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11629-020-6554-9