Abstract
Durability design of recycled high performance concrete (RHPC) is fundamental for improving the use rate and level of concrete waste as coarse recycled aggregate (CRA). We discussed a frost-durability-based mix proportion design method for RHPC using 100 % CRA and natural sand. Five groups of RHPC mixes with five strength grades (40, 50, 60, 70 and 80 MPa) were produced using CRA with four quality classes, and their workability, 28 d compressive strengths and frost resistances (measured by the compressive strength loss ratio and the relative dynamic modulus of elasticity) were tested. Relationships between the 28 d compressive strength, the frost resistance and the CRA quality characteristic parameter, water absorption, were then developed. The criterion of a CRA maximum water absorption limit value for RHPC was suggested, independent of its source and quality class. The results show that all RHPC mixes achieve the expected target workability, strength, and frost durability. The research results demonstrate that the application of the proposed method does not require trial testing prior to use.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Dilbas H, Simsek M, Cakir ǒ. An Investigation on Mechanical and Physical Properties of Recycled Aggregate Concrete (RAC) with and without Silica Fume[J]. Construction and Building Materials, 2014, 61: 50–59
Li Xuping. Recycling and Reuse of Waste Concrete in China Part I. Material Behavior of Recycled Aggregate Concrete[J]. Resources, Conservation and Recycling, 2008, 53(11): 36–44
Tam Vivian W Y, Tam C M, Wang Y. Optimization on Proportion for Recycled Aggregate in Concrete Using Two-stage Mixing Approach[J]. Construction and Building Materials, 2007, 21(10): 1928–1939
Zhang Sucheng. The Failure Mechanisms and Mix Design Method of High Performance Concrete Made from Recycled Aggregates Exposed to Freezing-thawing Environment[D]. Changzhou: Changzhou University, 2016
Chen Jiankui, Wang Dongmin. New Mix Design Method for HPCOverall Calculation Method[J]. Journal of the Chinese Ceramic Society, 2000, 28(2): 194–198
Bogas J Alexandre, Gomes Augusto. A Simple Mix Design Method for Structural Lightweight Aggregate Concrete[J]. Materials and Structures, 2013, 46: 1919–1932
China Building Industry Press. Lightweight Aggregates and Its Test Methods-Part 2: Test Methods for Lightweight Aggregates[S]. GB/T 17431.2-2010, 2010
Chandra S, Berntsson L. Lightweight Aggregate Concrete. Science, Technology and Applications[M]. New York: Noyes Publications-Wiliam Andrew Publishing, 2002
Bogas J A, Gomes A, Gloria MG. Estimation of Water Absorbed by Expanding Clay Aggregates during Structural Lightweight Concrete Production[J]. Material and Structures, 2012, 45(10): 1565–1576
Johannesson B. Dimensional and Ice Content Changes of Hardened Concrete at Different Freezing and Thawing Temperatures[J]. Cement Concrete and Composites, 2010, 32(1): 73–83
Jacobsen S. Calculating Liquid Transport into High-performance Concrete during Wet Freez/Thaw[J]. Cement and Concrete Research, 2005, 35(4): 213–219
Kou S C, Poon C S. Enhancing the Durability Properties of Concrete Prepared with Coarse Recycled Aggregate[J]. Construction and Building Materials, 2012, 35: 69–76
China Building Industry Press. Recycled Coarse Aggregate for Concrete[S]. GB/T 25177–2010, 2010
Author information
Authors and Affiliations
Corresponding authors
Additional information
Funded by the National Natural Science Foundation of China (No. 51278073), Prospective Joint Research Project of Jiangsu Province (No.BY2015027-23) and State Key Laboratory for GeoMechanics and Deep Underground Engineering, China University of Mining & Technology (No.SKLGDUEK1704)
Rights and permissions
About this article
Cite this article
Wang, X., Liu, W., Wei, D. et al. A simple mix proportion design method based on frost durability for recycled high performance concrete using fully coarse recycled aggregate. J. Wuhan Univ. Technol.-Mat. Sci. Edit. 32, 1119–1124 (2017). https://doi.org/10.1007/s11595-017-1720-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11595-017-1720-9