Abstract
Side weirs are among hydraulic structures which are utilized in flood control, urban sewage disposal networks, irrigation, and drainage channels. Today, thanks to computer science advancement, the use of numerical models has been increased owing to lesser time and lower costs compared with experimental models. The present study deals with investigating the flow pattern on a side weir in a converging rectangular channel using a commercial software employing RNG turbulence model and VOF method to simulate turbulence and free surface, respectively. One of the advantages of using side weirs is that after drainage it is unnecessary to continue the downstream channel with the previous width, and consequently it will be cost-effective. Comparing longitudinal velocities, water surface profiles, and flow discharge over a side weir with experimental results indicated the capability of the numerical model to simulate the flow pattern over a side weir. The effects of length changes of the side weir on the flow characteristics also were studied. Comparing parameters in different sections at the middle of the side weir showed that decreasing the length of the side weir increases the longitudinal velocity. Also, by decreasing the side weir length the passing discharge declined, and the free surface profile formed in higher height as well. The discrepancy between the specific energy at the upstream and that of the downstream of the weir for different side weir lengths was negligible.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Abbreviations
- \(A_x \) :
-
Fractional area of the element in x-direction
- \(A_y \) :
-
Fractional area of the element in y-direction
- \(A_z \) :
-
Fractional area of the element in z-direction
- F :
-
Fluid volume fraction
- \(f_i \) :
-
Reynolds tensions in I direction
- \(g_i \) :
-
Gravity acceleration in I direction
- u :
-
Velocity component in x-direction
- v :
-
Velocity component in y-direction
- w :
-
Velocity component in z-direction
- \(V_\mathrm{{F}}\) :
-
The ratio of fractional volume in each element
- VOF:
-
Volume of fluid
- P :
-
Pressure
- L :
-
The crest length of the side weir
- W :
-
The crest height of the side weir
- S :
-
The crest thickness of the side weir
- \(Q_0 \) :
-
Output discharge
- \(Q_\mathrm{{d}}\) :
-
Outflow discharge
- \(h_0 \) :
-
Output head
- \(h_\mathrm{{d}}\) :
-
Outflow head
- \(F_0 \) :
-
Output Froude number
- \(F_\mathrm{{d}}\) :
-
Outflow Froude number
- \(\rho \) :
-
Fluid density
References
De Marchi, G.: Essay on the performance of lateral weirs. L’Energ. Elettr. 11, 849–860 (1934)
Subramanya, K., Awasthy, S.C.: Spatially varied flow over side-weirs. J. Hydraul. Div. 98(1), 1–10 (1972)
Ranga Raju, K.G., Gupta, S.K., Prasad, B.: Side weir in rectangular channel. J. Hydraul. Div. 105(5), 547–554 (1979)
Hager, W.H.: Lateral outflow over side weirs. J. Hydraul. Eng. 113(4), 491–504 (1987)
Singh, R., Manivannan, D., Satyanarayana, T.: Discharge coefficient of rectangular side weirs. J. Irrig. Drain. Eng. 120(4), 814–819 (1994)
Borghei, S.M., Jalili, M.R., Ghodsian, M.: Discharge coefficient for sharp-crested side weir in subcritical flow. J. Hydraul. Eng. 125(10), 1051–1056 (1999)
Rao, K.D., Pillai, C.R.S.: Study of flow over side weirs under supercritical conditions. Water Resour. Manag. 22(1), 131–143 (2008)
Emiroglu, M.E., Kaya, N., Agaccioglu, H.: Discharge capacity of labyrinth side weir located on a straight channel. J. Irrig. Drain. Eng. 136(1), 37–46 (2009)
Mohammed, M.Y., Mohammed, A.Y.: Discharge coefficient for an inclined side weir crest using a constant energy approach. Flow Meas. Instrum. 22(6), 495–499 (2011)
Bagheri, S., Heidarpour, M.: Characteristics of flow over rectangular sharp-crested side weirs. J. Irrig. Drain. Eng. 138(6), 541–547 (2011)
Michelazzo, G., Oumeraci, H., Paris, E.: Laboratory study on 3D flow structures induced by zero-height side weir and implications for 1D modeling. J. Hydraul. Eng. 141(10), 04015023 (2015)
Ameri, M., Dehghani, A.A., Ahmadi, A.: Elementary discharge coefficient of a triangular–rectangular sharp-crested side weir in subcritical flow. Int. J. River Basin Manag. 14(1), 95–102 (2016)
Zahiri, A., Tang, X., Bagheri, S.: Flow discharge computation over compound sharp-crested side weirs. ISH J. Hydraul. Eng. 23(3), 1–5 (2017)
Qu, J.: Three-dimensional turbulence modeling for free surface flows. Doctoral dissertation, Concordia University (2005)
Mangarulkar, K.: Experimental and numerical study of the characteristics of side weir flows. Doctoral dissertation, Concordia University (2010)
Aydin, M.C.: CFD simulation of free-surface flow over triangular labyrinth side weir. Adv. Eng. Softw. 45(1), 159–166 (2012)
Abdollahi, A., Kabiri-Samani, A., Asghari, K., Atoof, H., Bagheri, S.: Numerical modeling of flow field around the labyrinth side-weirs in the presence of guide vanes. ISH J. Hydraul. Eng. 23(1), 71–79 (2017)
Maranzoni, A., Pilotti, M., Tomirotti, M.: Experimental and numerical analysis of side weir flows in a converging channel. J. Hydraul. Eng. 143(7), 04017009 (2017)
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Ghorbannia, D., Eghbalzadeh, A. Numerical study of the effect of length change on the flow pattern around a side weir in a converging channel. Acta Mech 229, 4101–4111 (2018). https://doi.org/10.1007/s00707-018-2215-2
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00707-018-2215-2