Abstract
This paper focus on the calibration for 6-UPS Stewart platform. By the kinematic analysis, it is found that the error of final position and posture is mainly influenced by radius and 6 angles of joint of movable platform. Therefore, this paper proposes a calibration method which compensates the radius and 6 angles. According to the error analysis, a method of compensating the parameters is proposed, which applied interior-point algorithm. A simulation is set to verify this method. It indicates that the method could compensate simulated error and apparently reduce the error of 6 axis lengths.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Similar content being viewed by others
References
Besnard S, Khalil W (2001) Identifiable parameters for parallel robots kinematic calibration. In: Proceedings 2001 ICRA, IEEE International Conference on Robotics and Automation (Cat. No. 01CH37164), vol 3. IEEE, pp 2859–2866
Yao R, Zhu W, Huang P (2013) Accuracy analysis of Stewart platform based on interval analysis method. Chin J Mech Eng 26(1):29–34
Khalil W, Besnard S (1999) Self calibration of Stewart-Gough parallel robots without extra sensors. IEEE Trans Robot Autom 15(6):1116–1121
Borm JH, Meng CH (1991) Determination of optimal measurement configurations for robot calibration based on observability measure. Int J Robot Res 10(1):51–63
Tsai LW (2000) Solving the inverse dynamics of a Stewart-Gough manipulator by the principle of virtual work. J Mech Des 122(1):3–9
Acknowledgments
This study was supported by ‘Study on Key technologies of Prarallel Robot for Minimally Invasive Spine Surgery’, Scientific Research Project of Shanghai Municipal Science and Technology Commission, (Projection No. 16090503700).
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2020 Springer Nature Singapore Pte Ltd.
About this paper
Cite this paper
Jing, X., Fang, Y., Wang, Z. (2020). A Calibration Method for 6-UPS Stewart Platform. In: Jia, Y., Du, J., Zhang, W. (eds) Proceedings of 2019 Chinese Intelligent Systems Conference. CISC 2019. Lecture Notes in Electrical Engineering, vol 593. Springer, Singapore. https://doi.org/10.1007/978-981-32-9686-2_58
Download citation
DOI: https://doi.org/10.1007/978-981-32-9686-2_58
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-32-9685-5
Online ISBN: 978-981-32-9686-2
eBook Packages: Intelligent Technologies and RoboticsIntelligent Technologies and Robotics (R0)