Abstract
Recent measurements highlight the importance of battery-aware evaluation of energy efficiency in wireless sensor networks. However, existing battery models been not investigated in the context of the low duty cycle, short duration loads that are typical of sensor networks. We evaluate three battery models with regard to their applicability in the WSN context. Our evaluation focuses on how the models reflect two key battery discharge behaviors, the rate capacity effect and charge recovery. We find that the models handle the former better than the latter and are more sensitive to a load’s peak current than to its timing.
Access provided by Autonomous University of Puebla. Download to read the full chapter text
Chapter PDF
Similar content being viewed by others
Keywords
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.
References
Feeney, L.M., Andersson, L., Lindgren, A., Starborg, S., Ahlberg Tidblad, A.: Poster abstract: Using batteries wisely. In: ACM Conf. on Embedded Networked Sensor Systems, Sensys (2012)
Battery Design LLC: Battery design studio, http://www.batsdesign.com
Manwell, J., McGowan, J.: Lead acid battery storage model for hybrid energy system. Solar Energy 50(5) (1993)
Kim, T., Qiao, W.: A hybrid battery model capable of capturing dynamic circuit characteristics and nonlinear capacity effects. IEEE Transactions on Energy Conversion 26(4) (2011)
RF Monolithics, Inc.: TR1001, http://www.rfm.com
Feeney, L.M., Andersson, L., Lindgren, A., Starborg, S., Ahlberg Tidblad, A.: Poster: A testbed for measuring battery discharge behavior. In: 7th ACM Int’l Workshop on Wireless Network Testbeds, Experimental Evaluation & Characterization, WiNTECH (2012)
Rao, R., Vrudhula, S., Rakhmatov, D.: Battery modeling for energy aware system design. IEEE Computer 36(12) (2003)
Rakhmatov, D.: Battery voltage modeling for portable systems. ACM Trans. on Design Automation of Electronic Systems (TODAES) 14(2) (2009)
Fuller, T.F., Doyle, M., Newman, J.: Simulation and optimization of the dual lithium ion insertion cell. Journal of the Electrochemical Society 141(1) (1994)
Jongerden, M.R., Haverkort, B.R.: Which battery model to use? IET Software 3(6) (2009)
Chen, M., Rinćon-Mora, G.: Accurate electrical battery model capable of predicting runtime and iv performance. IEEE Transactions on Energy Conversion 21(2) (2006)
Chau, C., Qin, F., Sayed, S., Wahab, M., Yang, Y.: Harnessing battery recovery effect in wireless sensor networks: Experiments and analysis. IEEE Journal on Selected Areas in Communications 28(7) (2010)
Park, C., Lahiri, K., Raghunathan, A.: Battery discharge characteristics of wireless sensor nodes: An experimental analysis. In: IEEE Conf. on Sensor and Ad-hoc Communications and Networks, SECON (2005)
Park, S., Savvides, A., Srivastava, M.B.: Battery capacity measurement and analysis using lithium coin cell battery. In: Int’l Symp. on Low Power Electronics & Design, ISLPED (2001)
Yeduvaka, G., Spotnitz, R., Gering, K.: Macro-homogenous modeling of commercial, primary Li/MnO2 coin cells. ECS (Electrochemical Society) Trans. 19(16) (2009)
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2013 Springer-Verlag Berlin Heidelberg
About this paper
Cite this paper
Rohner, C., Feeney, L.M., Gunningberg, P. (2013). Evaluating Battery Models in Wireless Sensor Networks. In: Tsaoussidis, V., Kassler, A.J., Koucheryavy, Y., Mellouk, A. (eds) Wired/Wireless Internet Communication. WWIC 2013. Lecture Notes in Computer Science, vol 7889. Springer, Berlin, Heidelberg. https://doi.org/10.1007/978-3-642-38401-1_3
Download citation
DOI: https://doi.org/10.1007/978-3-642-38401-1_3
Publisher Name: Springer, Berlin, Heidelberg
Print ISBN: 978-3-642-38400-4
Online ISBN: 978-3-642-38401-1
eBook Packages: Computer ScienceComputer Science (R0)