Abstract
In past decades, the technology of ankle-foot prosthesis is rapidly developing for lower-limb amputees to restore the lost function of the human ankle. Several powered ankle-foot prostheses are proposed with good performance on lever-ground walking at normal speed. However, compared with prosthesis focusing on a specific speed, the adaptability of different walking speeds is still a big challenge for current powered ankle-foot prosthesis. In this paper, the authors present the optimal design and analysis of a novel powered ankle-foot prosthesis by combining the typical SEA actuator with a length-adjustable lever arm. The prosthesis can adjust the system stiffness by changing the length of the lever arm. After the optimization of the length of the lever arm, the novel prosthesis can provide amputee good performance on torque mimicking at low speed, high energy efficiency at normal speed and reduction of peak power at high speed. This paper also gives insight to the benefit of adjustable mechanical system on the performance of the prosthesis to the future design of the powered ankle-foot prosthesis at different walking speeds.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Similar content being viewed by others
References
Casillas, J.-M., Dulieu, V., Cohen, M., et al.: Bioenergetic comparison of a new energy-storing foot and SACH foot in traumatic below-knee vascular amputations. Arch. Phys. Med. Rehabil. 76(1), 39–44 (1995)
Ham, R., Sugar, T., Vanderborght, B., et al.: Compliant actuator designs. Robot. Autom. Mag. IEEE 16(3), 81–94 (2009)
Bovi, G., Rabuffetti, M., Mazzoleni, P., et al.: A multiple-task gait analysis approach: kinematic, kinetic and EMG reference data for healthy young and adult subjects. Gait Posture 33(1), 6–13 (2011)
Palmer, M., et al.: Sagittal Plane Characterization of Normal Human Ankle Function Across a Range of Walking Gait Speeds. Massachusetts Institute of Technology, Cambridge (2002)
Andrysek, J., et al.: Lower-limb prosthetic technologies in the developing world: a review of literature from 1994–2010. Prosthet. Orthot. Int. 34(4), 378–398 (2010)
Versluys, R., Beyl, P.V.M.: Prosthetic feet: State-of-the-art review and the importance of mimicking human ankle–foot biomechanics. Disabil. Rehabil. Assist. Technol. 4(2), 65–75 (2009)
Davis, R., DeLuca, P.: Gait characterization via dynamic joint stiffness. Gait Posture 4(3), 224–231 (1996)
Hitt, J., Bellman, R., Holgate, M., et al.: The sparky (spring ankle with regenerative kinetics) project: design and analysis of a robotic transtibial prosthesis with regenerative kinetics. In: ASME 2007 International Design Engineering Technical Conferences and Computers and Information in Engineering Conference (2007)
Gao, F., Liu, Y., Liao, W.: A new powered ankle-foot prosthesis with compact parallel spring mechanism. In: 2016 IEEE International Conference on Robotics and Biomimetics (ROBIO). IEEE (2016)
Au, S.K., Weber, J., Herr, H.: Biomechanical design of a powered ankle-foot prosthesis. In: IEEE 10th International Conference on Rehabilitation Robotics IEEE (2007)
Cherelle, P., Junius, K., Grosu, V., et al.: The AMP-Foot 2.1: actuator design, control and experiments with an amputee. Robotica 32(08), 1347–1361 (2014)
Shepherd, M., Rouse, E.: The VSPA foot: a quasi-passive ankle-foot prosthesis with continuously variable stiffness. IEEE Trans. Neural Syst. Rehabil. Eng., 1534–4320 (2017)
LaPre, A., Wedge, R.: Umberger, B., et al.: Preliminary study of a robotic foot-ankle prosthesis with active alignment. In: IEEE (2017)
Herr, H., Grabowski, A.: Bionic ankle–foot prosthesis normalizes walking gait for persons with leg amputation. Proc. R. Soc. Lond. B Biol. Sci. 279(1728), 457–464 (2012)
Grimmer, M., Seyfarth, A.: Stiffness adjustment of a series elastic actuator in an ankle-foot prosthesis for walking and running: the trade-off between energy and peak power optimization. In: 2011 IEEE International Conference on Robotics and Automation (ICRA). IEEE (2011)
Winter, D.: Kinematic and kinetic patterns in human gait: variability and compensating effects. Hum. Mov. Sci. 3(1), 51–76 (1984)
Verstraten, T., Furnémont, R., Mathijssen, G., et al.: Energy consumption of geared DC motors in dynamic applications: comparing modeling approaches. IEEE Robot. Autom. Lett. 1(1), 524–530 (2016)
Acknowledgments
Dianbiao Dong is fund by the China Scholarship Council. This work is supported by the National Natural Science Foundation of China (50975230) and Research fund for the Doctoral Program of Higher Education of China (20136102130001).
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2019 Springer Nature Switzerland AG
About this paper
Cite this paper
Dong, D., Ge, W., Wang, J., Sun, Y., Zhao, D. (2019). Optimal Design and Analysis of a Powered Ankle-Foot Prosthesis with Adjustable Actuation Stiffness. In: Deng, K., Yu, Z., Patnaik, S., Wang, J. (eds) Recent Developments in Mechatronics and Intelligent Robotics. ICMIR 2018. Advances in Intelligent Systems and Computing, vol 856. Springer, Cham. https://doi.org/10.1007/978-3-030-00214-5_73
Download citation
DOI: https://doi.org/10.1007/978-3-030-00214-5_73
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-030-00213-8
Online ISBN: 978-3-030-00214-5
eBook Packages: Intelligent Technologies and RoboticsIntelligent Technologies and Robotics (R0)